* Expose uartStartDetectBaudrate(uart_t *) in esp32-hal-uart.h and call it from HardwareSerial::begin() if baudrate detection is requested (by passing a baudrate of 0) to solve baudrate detection problems
* Avoid a division by zero error in uartGetBaudRate()
* Add APB change callbacks and move cpu code to own file
* Properly set esp_timer and FreeRTOS tick dividers
* Improve updated devisors
* No need to update REF_TICK yet
* Add initial handling for UART baud change
* fix uartWriteBuf and uartDetectBaudrate
* trigger callbacks even when APB did not change
* toggle UART ISR on CPU change
* add XTAL freq getter and add cpu freq validation
* Support CPU frequency changes in I2C (#2287)
**esp32-hal-i2c.c**
* add callback for cpu frequency changes
* adjust fifo thresholds based on cpu frequency and i2c bus frequency
* reduce i2c bus frequency if differential is too small
**Wire.h**
* version to 1.1.0
* Implement clock change for the other peripherals
* remove bad CPU clock values from the menu
* Add note to CPU freqs that support WiFi and BT
* Add support to HAL for APB frequencies different than 80MHz
* Add support for CPU frequencies in the IDE board menu
* Switch to fast set_config
* Add method to uart so debug can be reassigned after apb frequency switch
* Return real APB frequency
* Added baudrate detection to esp32-hal-uart and HardwareSerial
* Solved compiler warning for uartResizeRxBuffer()
* Add unit to header variable name (timeout_ms)
* Reverting accidentally changed files to master
* Add small delay after baudrate detection
* uartEnd: Unlock mutex before detaching rx and tx
This should solve the device freezing issue when Serial.end() is called
* Unlock UART MUTEX only for detaching Rx and Tx
* Thanks to @me-no-dev for pointing it out that
uart->dev->conf0.val can be inside mutex lock
IDF Options:
- Autostart Arduino (implements app_main)
- Disable HAL locks
- Set HAL debug level
- Auto-connect STA if configured (else will connect after WiFi.begin())
