2.9 KiB
Building
Prerequisites
The build system of this repository is based on Make. The Makefile is in the base of the repository.
Firstly, figure out which MCU platform your supported board is based on. The table below can help you.
| Board name | Link | Transceiver | MCU | Description |
|---|---|---|---|---|
| Handheld v2.x RNodes | Buy here | SX1276 | ESP32 | |
| RAK4631 | Buy here | SX1262 | nRF52 | |
| LilyGO LoRa32 v1.0 | Buy here | SX1276/8 | ESP32 | |
| LilyGO T-BEAM v1.1 | Buy here | SX1276/8 | ESP32 | |
| LilyGO LoRa32 v2.0 | No link | SX1276/8 | ESP32 | Discontinued? |
| LilyGO LoRa32 v2.1 | Buy here | SX1276/8 | ESP32 | With and without TCXO |
| Heltec LoRa32 v2 | No link | SX1276/8 | ESP32 | Discontinued? |
| Heltec LoRa32 v3 | Buy here | SX1276/8 | ESP32 | |
| Homebrew ESP32 boards | Any supported | ESP32 | This can be any board with an Adafruit Feather (or generic) ESP32 chip |
ESP32
If your board is ESP32-based, please run make prep-esp32 to install the required BSP and libraries for that target.
nRF52
If your board is nRF52-based, please run make prep-nrf to install the required BSP and libraries for that target.
Compiling
Next, you need to find the name of the target for your board. Please reference the table below to do so:
| Board name | Target |
|---|---|
| Handheld v2.x RNodes | rnode_ng_20 |
| RAK4631 | rak4631 |
| LilyGO T-BEAM v1.1 | tbeam |
| LilyGO T-BEAM v1.1 (SX1262) | tbeam_sx126x |
| LilyGO LoRa32 v1.0 | lora32_v10 |
| LilyGO LoRa32 v2.0 | lora32_v20 |
| LilyGO LoRa32 v2.1 | lora32_v21 |
| Heltec LoRa32 v2 | heltec32_v2 |
| Heltec LoRa32 v3 | heltec32_v3 |
| Homebrew ESP32 boards | genericesp32 |
After you've ascertained the target for the board simply run the following to compile for the board:
make firmware-[target]
Ensure you replace [target] with the target you selected. For example:
make firmware-rak4631
Flashing
To flash the chosen board (if you have one), simply connect it to your computer over USB, and then run the following:
make upload-[target]
Ensure you replace [target] with the target you selected. For example:
make upload-rak4631
Please note, you must re-compile the firmware each time you make changes before you flash it, else you will just be flashing the previous version of the firmware without the new changes!
These commands can also be run as a one liner. For example:
make firmware-[target] && make upload-[target]
This is especially helpful when making continuous changes to the firmware and testing them out.